What Width Edge Banding Do I Need for Angled Edges?128

Calculating the correct width of edge banding for angled edges can be a bit tricky, but it's important to get it right. If the edge banding is too narrow, it will not cover the entire edge of the material and will leave a gap. If the edge banding is too wide, it will overhang the edge and create an unsightly appearance.

The formula for calculating the width of edge banding for angled edges is as follows:```
Width of edge banding = Thickness of material / Sine of the angle
```

For example, if you have a 1/2-inch thick piece of material and you want to apply edge banding to an edge that is angled at 45 degrees, the calculation would be as follows:```
Width of edge banding = 1/2 inch / Sine of 45 degrees
Width of edge banding = 1/2 inch / 0.707
Width of edge banding = 0.707 inches
```

Therefore, you would need to use 0.707-inch wide edge banding for this application.

It's important to note that this formula only works for angles that are less than 90 degrees. If the angle is greater than 90 degrees, you will need to use a different formula.

Here are some additional tips for applying edge banding to angled edges:
Use a sharp utility knife to cut the edge banding to the correct width.
Apply a thin layer of contact cement to both the edge of the material and the back of the edge banding.
Align the edge banding with the edge of the material and press it firmly into place.
Use a roller or a burnishing tool to ensure that the edge banding is securely adhered to the material.
Trim any excess edge banding with a sharp utility knife.

By following these tips, you can ensure that your edge banding projects turn out looking their best.

2024-10-17

Previous：How to Edge Band a Curved Surface: A Step-by-Step Guide with Pictures

Next：How to Apply Wood Grain Edge Banding