How to Apply Aluminum Edging to Curved Edges81

Adding aluminum edging to curved edges can enhance the appearance and durability of your furniture. This guide will teach you step-by-step how to apply aluminum edging to curved edges with ease. Whether you're a seasoned craftsman or a DIY enthusiast, this comprehensive guide has got you covered.

Materials You'll Need:
Aluminum edging
Heat gun or hairdryer
Plastic spatula or edge banding trimmer
Rubber mallet
Tack cloth or damp cloth
Optional: Aluminum edging adhesive

Step-by-Step Instructions:

Step 1: Prepare the Edge

Use a tack cloth or damp cloth to clean the curved edge of your furniture. Remove any dust, debris, or adhesive residue that may hinder the adhesion of the aluminum edging.

Step 2: Heat the Edging

Hold the heat gun or hairdryer close to the aluminum edging. Move it back and forth along the entire length of the edging to heat it up evenly. The edging will become pliable and easier to shape.

Step 3: Bend the Edging

While the aluminum edging is still hot, use your fingers or a plastic spatula to bend it around the curved edge. Press firmly to ensure a snug fit.

Step 4: Trim the Edging

Once the aluminum edging is bent into place, use an edge banding trimmer or a sharp utility knife to trim any excess edging from the ends.

Step 5: Secure the Edging

If desired, you can apply a thin layer of aluminum edging adhesive to the underside of the edging. This will help to create a more secure bond between the edging and the furniture.

Step 6: Heat and Press the Edging

Reheat the aluminum edging with the heat gun or hairdryer. Use a rubber mallet or a rolling pin to press the edging firmly into place. This will ensure that the edging is properly adhered to the curved edge.

Step 7: Finish the Edge

Allow the aluminum edging to cool completely. Once it has cooled, you can use a damp cloth to wipe away any adhesive residue or excess heat.

Tips for Perfect Results:
Practice your technique on scrap pieces before applying the edging to your furniture.
Use a heat gun or hairdryer on a low setting to avoid burning the aluminum edging.
Work slowly and carefully to ensure a clean and precise bend.
If the aluminum edging starts to cool down, reheat it before continuing.
Use a rubber mallet or a rolling pin to apply even pressure while pressing the edging into place.

By following these steps and tips, you can achieve professional-looking results when applying aluminum edging to curved edges. This will not only enhance the aesthetics of your furniture but also provide additional protection and durability.

2024-10-17

Previous：How to Apply Edgebanding Without Joints

Next：Edgebanding Veneer vs. Edgebanding Strip: What‘s the Difference?