How to Edge Band a Cabinet Without an Edging Machine75

IntroductionEdge banding is an essential part of cabinet making, as it protects the exposed edges of the plywood or MDF from moisture and damage, and gives it a finished look. Traditionally, edge banding is done using an automatic edge banding machine, which applies a pre-glued edge banding tape to the edge of the board. However, if you don't have access to an edge banding machine, there are a few other methods you can use to edge band a cabinet without an edging machine.##

Method 1: Using Wood Glue and Iron-On Edge Banding##

This method is the easiest and most affordable way to edge band a cabinet without an edging machine. You will need the following materials:- Iron-on edge banding
- Wood glue
- A hot iron
- A sharp knife
- A sanding block
##

Instructions1. Cut the edge banding to the length of the edge you need to cover.
2. Apply a thin layer of wood glue to the edge of the cabinet.
3. Place the edge banding over the glue and press it down with a hot iron.
4. Hold the iron in place for a few seconds until the glue sets.
5. Use a sharp knife to trim any excess edge banding.
6. Sand the edge banding flush with the surface of the cabinet.##

Method 2: Using Contact Cement and Veneer Tape##

This method is a bit more difficult than using iron-on edge banding, but it will produce a more durable bond. You will need the following materials:- Veneer tape
- Contact cement
- A brush or roller
- A sharp knife
- A sanding block
##

Instructions1. Cut the veneer tape to the length of the edge you need to cover.
2. Apply a thin layer of contact cement to the edge of the cabinet and to the back of the veneer tape.
3. Let the contact cement dry for a few minutes until it becomes tacky.
4. Align the veneer tape with the edge of the cabinet and press it down firmly.
5. Use a sharp knife to trim any excess veneer tape.
6. Sand the veneer tape flush with the surface of the cabinet.##

Method 3: Using Wood Filler and Sanding##

This method is the most time-consuming, but it will produce a seamless edge that is indistinguishable from the rest of the cabinet. You will need the following materials:- Wood filler
- A putty knife
- A sanding block
- A sharp knife
##

Instructions1. Fill the exposed edge of the cabinet with wood filler.
2. Use a putty knife to smooth the wood filler and remove any excess.
3. Let the wood filler dry completely.
4. Sand the wood filler flush with the surface of the cabinet.
5. Use a sharp knife to create a chamfer or roundover on the edge of the cabinet.

2024-10-18

Previous：How to Manually Apply Edge Banding to Furniture

Next：How to Edge Band with Flat PVC Edge Banding