How to Use Edge Banding Adhesive on Double-Sided Edge Banding306

Edge banding adhesive is a necessary part of the edge banding process. It helps to adhere the edge banding to the substrate, creating a strong and durable bond. There are two main types of edge banding adhesive: hot melt adhesive and cold melt adhesive. Hot melt adhesive is applied hot and melts the edge banding to the substrate. Cold melt adhesive is applied cold and dries to form a strong bond.

When choosing an edge banding adhesive, it is important to consider several factors, including:
The type of substrate
The thickness of the edge banding
The desired bond strength
The environmental conditions

Once you have selected an edge banding adhesive, you can follow these steps to apply it to double-sided edge banding:1. Prepare the surface. The surface of the substrate should be clean and free of dust or debris.
2. Apply the adhesive. Apply a thin, even coat of adhesive to the surface of the substrate.
3. Position the edge banding. Align the edge banding with the edge of the substrate and press it down firmly.
4. Hold the edge banding in place. Hold the edge banding in place for a few minutes to allow the adhesive to set.
5. Trim the excess adhesive. Once the adhesive has set, trim any excess adhesive that has oozed out from the sides of the edge banding.

By following these steps, you can successfully apply edge banding adhesive to double-sided edge banding. This will help to create a strong and durable bond between the edge banding and the substrate.

Here are some additional tips for using edge banding adhesive:* Use a spatula or roller to apply the adhesive evenly to the surface of the substrate.
* Do not apply too much adhesive, as this can cause the edge banding to bubble or peel.
* Allow the adhesive to set for a few minutes before trimming the excess adhesive.
* If the adhesive gets on your skin, wash it off immediately with soap and water.
* Store the adhesive in a cool, dry place.

2024-10-21

Previous：How to Perfectly Seal Edge Banding on Rounded Corners

Next：How to Edge Band with T-Molding Rubber Trim