How to Edgeband Veneer with a Groove86

Veneer edging is a common technique used in furniture making to create a seamless and finished look. However, when there is a groove in the veneer, it can be challenging to achieve a clean and professional edgeband. In this article, we will explore different methods and provide detailed instructions on how to edgeband veneer with a groove effectively.

Methods for Edgebanding Veneer with a GrooveThere are two primary methods for edgebanding veneer with a groove:
Using a Router with a Groove Bit
Using a Handheld Edger

Method 1: Using a Router with a Groove Bit

This method is suitable for edgebanding large or complex shapes with precision. Here's how to do it:
Select a router bit with a diameter slightly larger than the groove.
Set up the router with the correct depth to match the depth of the groove.
Secure the veneer to the workpiece using clamps or double-sided tape.
Align the router base along the edge of the veneer, ensuring the bit is centered over the groove.
Slowly and carefully route the edgeband into the groove, following the contours of the workpiece.
Trim off any excess edgeband using a utility knife or a flush trim router bit.

Method 2: Using a Handheld Edger

This method is ideal for smaller or straight edgebanding applications. Here are the steps:
Choose a handheld edger with a blade that is sharp and carbide-tipped.
Set the depth of the blade to slightly below the depth of the groove.
Secure the veneer to the workpiece as in Method 1.
Position the edger at the starting point of the groove and align the blade with the edge of the veneer.
Apply gentle pressure and move the edger along the groove, keeping the blade perpendicular to the surface.
Trim off any excess edgeband as in Method 1.

Tips for Edgebanding Veneer with a Groove
Use a high-quality edgeband that is compatible with your veneer.
Ensure the veneer and workpiece are clean and dry before edgebanding.
Test your settings on a scrap piece before edgebanding the actual workpiece.
Apply a small amount of glue to the groove before inserting the edgeband.
Clamp the edgeband firmly for several hours or overnight to ensure a secure bond.
Sand and finish the edgeband to match the surrounding surface.

Conclusion

Edgebanding veneer with a groove requires careful preparation and precise techniques. By following the methods and tips outlined in this article, you can achieve professional-quality edgebanding results. With patience and attention to detail, you can create beautiful and durable furniture that showcases the beauty of your veneers.

2024-10-21

Previous：How to Edge Band with Your Own Edge Banding

Next：How to Repair Unbound Edge Banding on Furniture? [Video]