How to PVC Edge Band Rounded Edges: A Step-by-Step Guide309

PVC edge banding is a common and effective way to finish the raw edges of furniture and other wood products. It provides a clean, professional look and protects the core material from moisture and wear. While PVC edge banding is typically applied to straight edges, it can also be used on rounded edges with a little extra care.

In this guide, we will show you how to PVC edge band rounded edges using a handheld router and a custom-made jig. This method is relatively simple and can be used to achieve professional results. We also provide additional tips on how to choose the right PVC edge banding and how to get a perfect finish.Step 1: Gather Your Materials
* PVC edge banding
* Handheld router
* Router bit (1/4-inch diameter, straight bit)
* Custom-made jig
* Clamps
* Safety glasses
* Dust mask
Step 2: Prepare the Edge Banding
* Cut the PVC edge banding to the desired length.
* Apply a thin layer of wood glue to the back of the edge banding.
Step 3: Set Up the Router
* Install the router bit into the router.
* Adjust the router's depth of cut so that the bit just barely touches the edge of the workpiece.
* Attach the custom-made jig to the router base. The jig should be designed to hold the workpiece securely and guide the router bit along the edge.
Step 4: Clamp the Workpiece
* Clamp the workpiece to the workbench or sawhorses.
* Make sure the workpiece is securely clamped so that it will not move during routing.
Step 5: Rout the Edge
* Position the router over the edge of the workpiece.
* Turn on the router and slowly feed the workpiece into the bit.
* Keep the router moving at a steady pace and be careful not to push too hard.
Step 6: Remove the Jig
* Once the edge has been routed, turn off the router and remove the jig.
* Be careful not to touch the hot router bit or the freshly routed edge.
Step 7: Apply the Edge Banding
* Apply a thin layer of wood glue to the routed edge.
* Position the edge banding over the glue and press it firmly into place.
* Clamp the edge banding in place using clamps.
Step 8: Trim the Edge Banding
* Once the glue has dried, trim the excess edge banding using a sharp knife or utility knife.
* Be careful not to cut into the workpiece.
Step 9: Sand the Edge
* Sand the edge of the workpiece to smooth out any rough edges.
* Use a fine-grit sandpaper and be careful not to sand through the edge banding.
Tips
* Use a sharp router bit. A dull bit will tear the edge banding and make it difficult to get a clean finish.
* Clamp the workpiece securely. If the workpiece moves during routing, it could cause the edge banding to shift and produce a poor-quality joint.
* Apply a thin layer of wood glue to the routed edge. The glue will help to hold the edge banding in place and prevent it from peeling off.
* Trim the edge banding carefully. Use a sharp knife or utility knife and be careful not to cut into the workpiece.
* Sand the edge of the workpiece to smooth out any rough edges. Use a fine-grit sandpaper and be careful not to sand through the edge banding.