How to fix broken edge binding on Chinese furniture50

Edge binding plays an important role in finishing Chinese furniture aesthetically and structurally. Not only does it provide a smooth transition from the edge of the furniture to the surface, but it also protects the edges from chipping, warping, and moisture penetration. However, sometimes mistakes can happen during the application of edge binding, and the results can be frustrating. If you're facing the problem of broken edge binding, don't panic. It is possible to remove and replace the damaged binding without causing further damage to your furniture.

Step 1: Gather Your Materials

Before you begin, you'll need to gather the following materials:* A heat gun or hair dryer
* A putty knife or scraper
* A sharp utility knife
* A new edge binding strip (matching the original binding)
* Wood glue
* A soft cloth or sponge
* Clamps (optional)

Step 2: Loosen the Adhesive

Using a heat gun or hair dryer, gently heat the broken edge binding. This will soften the adhesive, making it easier to remove. Be careful not to overheat the binding and damage the furniture.

Step 3: Scrape Off the Old Binding

Once the adhesive has softened, use a putty knife or scraper to carefully scrape away the broken edge binding. Work slowly and gently to avoid damaging the furniture. If the binding is particularly stubborn, you can use a sharp utility knife to cut through it.

Step 4: Clean the Surface

With the old binding removed, use a soft cloth or sponge to clean the surface of the furniture. Remove any remaining adhesive or debris.

Step 5: Apply Wood Glue

Apply a thin layer of wood glue to the edge of the furniture where the new binding will be applied. Be sure to spread the glue evenly.

Step 6: Apply the New Binding

Align the new edge binding strip with the edge of the furniture. Press the binding into place and use clamps to hold it securely while the glue dries. Make sure the binding is flush with the surface of the furniture.

Step 7: Trim the Excess Binding

Once the glue has dried, use a sharp utility knife to trim any excess binding that extends beyond the edge of the furniture.

Tips:* If you're using a heat gun, be sure to hold it at a distance to avoid scorching the furniture.
* To avoid damaging the furniture, use a plastic putty knife or scraper.
* If you're having difficulty removing the old binding, you can try using a solvent such as acetone or mineral spirits.
* For best results, use a sharp utility knife to trim the excess binding.
* If necessary, you can protect the surface of the furniture by covering it with masking tape before using the heat gun or hair dryer.

2024-10-22

Previous：How To Edgeband A Wide Edgeband

Next：How to Edge Band an Inside Corner