How to Seal Backer Rail Edge Banding24

Backer rail edge banding is a long, thin strip of material used to seal and finish the exposed edges of backer rails, which are the vertical supports at the back of a cabinet or drawer. Edge banding creates a clean and finished look, prevents moisture and dirt from entering the backer rail, and helps to strengthen the overall structure of the cabinet or drawer.

There are several different methods for sealing backer rail edge banding, including:
Iron-on edge banding: This is the most common method of sealing backer rail edge banding. Iron-on edge banding is applied with a hot iron, which melts the adhesive on the back of the edge banding and bonds it to the backer rail. Iron-on edge banding is relatively easy to apply, but it is important to use the correct temperature and pressure to ensure a strong bond.
Contact cement edge banding: Contact cement edge banding is applied with a special type of adhesive that creates a strong bond between the edge banding and the backer rail. Contact cement edge banding is more difficult to apply than iron-on edge banding, but it creates a very strong bond that is resistant to moisture and heat.
Pre-glued edge banding: Pre-glued edge banding has a self-adhesive backing that makes it easy to apply. Simply peel off the backing and press the edge banding onto the backer rail. Pre-glued edge banding is a good option for quick and easy applications, but it is important to make sure that the adhesive is strong enough to hold the edge banding in place.

Once you have chosen a method for sealing backer rail edge banding, follow these steps to apply it:
Prepare the surface: Clean the surface of the backer rail with a damp cloth and allow it to dry completely. Remove any dust or debris from the surface.
Apply the edge banding: If you are using iron-on edge banding, heat the iron to the correct temperature. Apply a thin layer of adhesive to the back of the edge banding and press it onto the backer rail. Use a J-roller or edge banding roller to apply pressure and ensure a strong bond.
If you are using contact cement edge banding, apply a thin layer of adhesive to both the back of the edge banding and the surface of the backer rail. Allow the adhesive to dry for a few minutes, then press the edge banding onto the backer rail. Use a J-roller or edge banding roller to apply pressure and ensure a strong bond.
If you are using pre-glued edge banding, simply peel off the backing and press the edge banding onto the backer rail. Use a J-roller or edge banding roller to apply pressure and ensure a strong bond.
Trim the edge banding: Once the edge banding is applied, use a sharp knife or edge banding trimmer to trim the excess material. Be careful not to cut into the backer rail.
Sand the edge banding: Sand the edge banding lightly with a fine-grit sandpaper to smooth any rough edges and create a finished look.

By following these steps, you can seal backer rail edge banding and create a clean and finished look for your cabinets or drawers.

2024-10-22

Previous：How to Edgeband Round Surfaces

Next：What is Edge Banding?