How to Fix the Fallen Edging Strip of Your Chinese Furniture380

Edging strips are an essential part of Chinese furniture, as they protect the edges of the furniture from damage and give it a finished look. However, over time, these strips can become loose or fall off, leaving your furniture looking unsightly and vulnerable to further damage. If you find yourself in this situation, don't worry - there are a few simple steps you can take to fix the problem yourself.

Step 1: Clean the Surfaces

Before attempting to reattach the edging strip, it is important to clean the surfaces of the furniture and the strip itself. This will remove any dirt or debris that could prevent the adhesive from adhering properly. Use a damp cloth and a mild detergent to clean the surfaces, then dry them thoroughly with a clean cloth.

Step 2: Apply Adhesive

Once the surfaces are clean, you will need to apply adhesive to the back of the edging strip. You can use a variety of adhesives for this purpose, but we recommend using a strong, flexible adhesive that is specifically designed for furniture repair. Apply a thin, even layer of adhesive to the back of the strip, making sure to cover the entire surface.

Step 3: Reattach the Edging Strip

Now it is time to reattach the edging strip to the furniture. Carefully align the strip with the edge of the furniture and press it into place. Use your fingers to apply pressure along the entire length of the strip, making sure that it is firmly attached. You may need to use a rubber mallet or a hammer to tap the strip into place, but be careful not to damage the furniture.

Step 4: Allow the Adhesive to Dry

Once the edging strip is in place, you will need to allow the adhesive to dry completely. This may take several hours or even overnight, depending on the type of adhesive you used. During this time, do not move or use the furniture, as this could cause the adhesive to fail.

Step 5: Clean Up

Once the adhesive has dried, you can clean up any excess adhesive that may have squeezed out from under the edging strip. Use a damp cloth to wipe away the excess adhesive, then dry the surface with a clean cloth. Your furniture is now repaired and looking good as new!

Tips
If you are having difficulty removing the old edging strip, you can use a heat gun or a hair dryer to soften the adhesive.
If the edging strip is damaged, you can replace it with a new one. Edging strips are available in a variety of sizes and finishes, so you can find one that matches your furniture perfectly.
To prevent the edging strip from falling off again, you can apply a clear sealant to the edge of the furniture. This will help to protect the adhesive and keep the strip in place.

2024-11-12

Previous：How to Apply Edge Banding: A Comprehensive Guide for Furniture Manufacturers

Next：How to Photograph Edge Banding: A Guide for Capturing the Perfect Shot