How to Install Edge Banding: A Step-by-Step Guide108

Edge banding is a thin strip of material that is applied to the exposed edges of plywood, MDF, or other wood panels to give them a finished look. It can also be used to create decorative effects or to protect the edges of the panel from damage. Edge banding is available in a variety of materials, including wood, plastic, and metal. In this guide, we will show you how to install edge banding using a hand-held router and a flush trim bit.

Materials you will need:
Edge banding
Hand-held router
Flush trim bit
Carpenter's glue
Clamps
Sandpaper
Safety glasses
Dust mask

Safety first:

Before you begin, put on safety glasses and a dust mask. Edge banding can create a lot of dust, so it is important to protect your eyes and lungs. Also, be sure to use a sharp flush trim bit. A dull bit can tear the edge banding and make it difficult to get a clean finish.

Step 1: Prepare the edge banding

Start by cutting the edge banding to the desired length. The edge banding should be slightly longer than the edge of the panel. Apply a thin layer of carpenter's glue to the back of the edge banding. Do not apply too much glue, or it will squeeze out when you clamp the edge banding in place.

Step 2: Align the edge banding

Place the edge banding on the edge of the panel, aligning the edge of the banding with the edge of the panel. Use a clamp to hold the edge banding in place. Make sure that the clamp is tight enough to hold the edge banding securely, but not so tight that it crushes the banding.

Step 3: Route the edge banding

Attach the flush trim bit to the router. The flush trim bit should be the same diameter as the edge banding. Adjust the depth of the router so that the bit will trim the edge banding flush with the surface of the panel. Slowly route along the edge of the panel, following the edge of the banding. Be careful not to push the router too quickly, or you may tear the edge banding.

Step 4: Sand the edge banding

Once you have routed the edge banding, sand it lightly to remove any splinters or rough edges. Use a fine-grit sandpaper and sand with the grain of the wood. Be careful not to sand too much, or you may damage the edge banding.

Step 5: Enjoy your finished project!

Your edge banding is now installed. You can now enjoy your finished project!

2024-12-01

Previous：How to Fix Wardrobe Edging Falling Off? Here‘s the Ultimate Guide

Next：How to Process Edge Banding in a Chinese Furniture Factory