How to Remove Chinese Furniture Veneer Edgebanding381

Edgebanding is a thin strip of wood, plastic, or metal that is applied to the exposed edges of a piece of furniture or other woodworking project. It serves both a decorative and structural purpose, hiding the raw edges of the wood and protecting it from damage. Occasionally, it may become necessary to remove the edgebanding, for example, if you want to refinish the furniture or replace a damaged section. Removing Chinese furniture veneer edgebanding can be a delicate task, but it is possible with a little care and patience.

Materials You Will Need:* Sharp utility knife
* Heat gun or hair dryer
* Putty knife or dental floss
* Sandpaper
* Wood glue
* Clamps
* New edgebanding (if necessary)

Step 1: Score the Edgebanding

Use a sharp utility knife to score a shallow line along the length of the edgebanding, as close to the edge of the furniture as possible. Be careful not to cut too deeply into the wood.

Step 2: Apply Heat

Use a heat gun or hair dryer to apply heat to the edgebanding. This will soften the glue that holds it in place and make it easier to remove.

Step 3: Remove the Edgebanding

Use a putty knife or dental floss to gently pry the edgebanding away from the furniture. Work slowly and carefully to avoid damaging the wood.

Step 4: Clean the Edge

Once the edgebanding has been removed, use sandpaper to clean the edge of the furniture. Remove any remaining glue or debris.

Step 5: Apply New Edgebanding (Optional)

If you are replacing the edgebanding, apply a thin layer of wood glue to the edge of the furniture. Then, press the new edgebanding into place and clamp it securely. Allow the glue to dry for several hours.

Tips:* Always test the heat gun or hair dryer on a small, inconspicuous area of the furniture to make sure it does not damage the finish.
* Be patient and take your time. Trying to remove the edgebanding too quickly can damage the wood.
* If the edgebanding is particularly stubborn, you can try using a combination of heat and acetone. Apply a small amount of acetone to the edgebanding and then apply heat. This will help to dissolve the glue and make the edgebanding easier to remove.
* Once the new edgebanding has been applied, trim it flush with the edge of the furniture using a sharp utility knife.

2024-12-06

Previous：How to Match Edge Banding: A Comprehensive Guide for Furniture Manufacturers

Next：How to Load Edge Banding onto a Vehicle