How to Change Edge Banding on Furniture243

Edge banding is a thin strip of material that is applied to the edges of furniture to protect them from damage and give them a finished look. Over time, edge banding can become damaged or worn, and you may need to replace it. Replacing edge banding is a relatively simple process that can be done with a few basic tools.

Materials You Will Need
New edge banding
Iron or clothes steamer
Adhesive
Trimming tool
Sandpaper

Steps1. Remove the old edge banding. Use a sharp knife or chisel to carefully remove the old edge banding from the furniture. Be careful not to damage the furniture itself.
2. Clean the surface. Once the old edge banding has been removed, clean the surface of the furniture with a damp cloth to remove any dirt or debris.
3. Apply adhesive to the surface. Apply a thin layer of adhesive to the surface of the furniture where the new edge banding will be applied.
4. Apply the new edge banding. Lay the new edge banding over the adhesive and press it down firmly. Use a roller or burnishing tool to ensure that the edge banding is securely bonded to the furniture.
5. Trim the excess edge banding. Use a trimming tool to trim the excess edge banding from the ends of the furniture.
6. Sand the edges. Use sandpaper to smooth the edges of the edge banding and blend it in with the furniture.

Tips
Use a heat gun or clothes steamer to help the adhesive bond more securely.
If the edge banding is thick, you may need to use a router to create a groove for it.
Be sure to use a sanding block to avoid damaging the edge banding.
If you are not comfortable changing edge banding yourself, you can hire a professional to do it for you.

ConclusionReplacing edge banding is a relatively simple process that can be done with a few basic tools. By following the steps outlined in this article, you can give your furniture a new and updated look.

2024-12-08

Previous：What‘s Causing Your Edge Banding to Overhang? Troubleshooting Tips

Next：Why Do Edge Banding Strips Smell? What Causes the Odor in Edge Banding?