How to Edge Band Ceiling Cove Moldings80

Cove moldings are a popular way to add a decorative touch to the ceiling of a room. They can be made from a variety of materials, including wood, plaster, and polystyrene. While cove moldings are relatively easy to install, edge banding them can be a bit tricky. Here is a step-by-step guide on how to edge band ceiling cove moldings:

Materials you will need:* Cove molding
* Edge banding tape
* Iron
* Scissors
* Measuring tape
* Pencil
* Safety glasses

Instructions:1.

Prepare the cove molding

The first step is to prepare the cove molding. If the molding is made of wood, you will need to sand it smooth. If the molding is made of plaster or polystyrene, you can skip this step.2.

Measure and cut the edge banding tape

Next, you will need to measure and cut the edge banding tape. The tape should be long enough to cover the entire length of the cove molding, plus a few inches extra. Once you have measured and cut the tape, fold it in half lengthwise.3.

Apply the edge banding tape

Now, you are ready to apply the edge banding tape to the cove molding. Start by applying a thin layer of adhesive to the back of the tape. Then, carefully align the tape with the edge of the cove molding and press it into place. Use your iron to heat the tape and bond it to the molding. Be sure to wear safety glasses when using the iron.4.

Trim the excess tape

Once the edge banding tape is applied, you will need to trim the excess tape. Use a sharp knife or scissors to carefully trim the tape flush with the edge of the cove molding.5.

Sand the edges

Finally, you will need to sand the edges of the cove molding to smooth them out. Use a fine-grit sandpaper and lightly sand the edges until they are smooth to the touch.

Tips* If you are using a wooden cove molding, it is important to prime the molding before applying the edge banding tape. This will help to prevent the tape from peeling off.
* When applying the edge banding tape, be sure to use a thin layer of adhesive. Too much adhesive can cause the tape to bubble or wrinkle.
* If you are using a polystyrene cove molding, be sure to use a low-temperature iron. Too much heat can damage the polystyrene.
* Be sure to wear safety glasses when using the iron. The iron can get very hot and could cause serious burns if not used carefully.

2024-12-12

---

Previous：How to Install Kitchen Cabinet Edge Banding

Next：How to Handle the Gap in Furniture Edge Banding