How to Fix Overhang Edge Banding187

Edge banding is an essential part of any furniture project. It helps to protect the edges of your furniture from damage and wear, and it can also give your furniture a more finished look. However, it can be frustrating when the edge banding doesn't quite reach the edge of your furniture, leaving an overhang. Here are a few tips on how to fix overhang edge banding:

1. Use a utility knife to trim the overhang. This is the simplest and most effective way to fix overhang edge banding. Simply score the edge banding along the edge of your furniture with a utility knife, and then snap the excess off. Be careful not to cut into the furniture itself.

2. Use a sanding block to sand the overhang. If you don't have a utility knife, you can also use a sanding block to sand the overhang off. Start with a coarse-grit sandpaper, and then gradually switch to a finer-grit sandpaper until the overhang is gone. Be sure to sand in the direction of the grain to avoid damaging the edge banding.

3. Use a heat gun to melt the overhang. If the edge banding is made of a thermoplastic material, such as PVC or ABS, you can use a heat gun to melt the overhang and then smooth it out with a putty knife. Be careful not to overheat the edge banding, or it will become damaged.

4. Use a solvent to dissolve the overhang. If the edge banding is made of a solvent-soluble material, such as acrylic or polystyrene, you can use a solvent to dissolve the overhang. Apply the solvent to a cloth and then rub it over the overhang until it dissolves. Be sure to wear gloves and eye protection when using solvents.

5. Replace the edge banding. If the overhang is too large to be repaired, you may need to replace the edge banding. This is a more involved process, but it is the only way to ensure that the edge banding is properly applied.

By following these tips, you can easily fix overhang edge banding and give your furniture a more finished look.

2024-12-14

Previous：Edge Banding Won‘t Stick to the Edge? Here‘s What You Need to Know

Next：How to Trim Round Edging Strips