How to Remove Hammer-On Edge Banding298

Hammer-on edge banding is a thin strip of material, usually made of wood or plastic, that is applied to the exposed edges of your furniture to give it a finished look. It is often used on cabinets, shelves, and other furniture pieces. Over time, hammer-on edge banding can become damaged or loose, and you may need to remove it to repair or replace it. Removing hammer-on edge banding is a relatively easy process, but it does require some care and patience.Here are the steps on how to remove hammer-on edge banding:

Gather your tools. You will need a sharp utility knife, a flathead screwdriver, a heat gun or hair dryer, and a pair of pliers.
Score the edge banding. Use the utility knife to score the edge banding along its length. This will help to weaken the adhesive holding it in place.
Insert the flathead screwdriver. Insert the flathead screwdriver into the score that you made in the edge banding. Gently pry up the edge banding, taking care not to damage the underlying wood or veneer.
Apply heat. Use the heat gun or hair dryer to apply heat to the edge banding. This will help to soften the adhesive and make it easier to remove.
Pull off the edge banding. Once the adhesive has softened, you should be able to pull the edge banding off with your hands. If it is still stuck, you can use the pliers to gently pull it off.
Clean up the surface. Once the edge banding has been removed, you can clean up the surface with a damp cloth. This will remove any remaining adhesive residue.

Here are some additional tips for removing hammer-on edge banding:
* If you are having trouble removing the edge banding, you can try using a chemical adhesive remover. However, be sure to test the remover on an inconspicuous area first to make sure that it does not damage the finish of your furniture.
* If you are removing hammer-on edge banding from a veneered surface, be very careful not to damage the veneer.
* If you are removing hammer-on edge banding from a curved surface, you can use a heat gun or hair dryer to soften the adhesive and then use your fingers to gently bend the edge banding away from the surface.
Once you have removed the hammer-on edge banding, you can replace it with new edge banding.
Here are the steps on how to apply new edge banding:

Apply adhesive to the edge of the furniture. Use a thin layer of contact cement or wood glue to the edge of the furniture where you will be applying the edge banding.
Apply the edge banding. Press the edge banding into place on the edge of the furniture. Use a roller or a J-roller to press the edge banding into place and remove any air bubbles.
Trim the edge banding. Use a utility knife to trim the excess edge banding from the ends of the furniture.
Sand the edge banding. Use a fine-grit sandpaper to sand the edge banding flush with the surface of the furniture.