How to Apply Non-Adhesive Edgebanding to Furniture115

Edgebanding is a thin strip of material used to cover the exposed edges of furniture, creating a finished and professional look. Non-adhesive edgebanding does not have any pre-applied glue, so it requires a separate adhesive to be applied before it can be attached to the furniture. This type of edgebanding is typically used for more complex applications where a precise fit is required, or when the surface of the furniture is not suitable for the application of pre-glued edgebanding.

Applying non-adhesive edgebanding requires a few simple tools and materials, including:
Non-adhesive edgebanding
Contact cement or wood glue
Edgebanding trimmer
Sandpaper or sanding block
Clean rag or cloth
Hammer or mallet

Here are the steps involved in applying non-adhesive edgebanding to furniture:

1. Prepare the Surface

Before applying the edgebanding, the surface of the furniture must be clean, dry, and free of any dust or debris. Sand any rough edges or splinters to create a smooth surface for the edgebanding to adhere to.

2. Apply Adhesive

Apply a thin, even layer of contact cement or wood glue to the edge of the furniture and the back of the edgebanding. Use a brush or a clean rag to spread the adhesive evenly. Allow the adhesive to dry for a few minutes according to the manufacturer's instructions.

3. Position the Edgebanding

Carefully align the edgebanding with the edge of the furniture. Press down firmly along the length of the edgebanding to ensure a secure bond. Use a hammer or mallet to tap the edgebanding into place if necessary.

4. Trim the Excess

Once the edgebanding is in place, use an edgebanding trimmer to remove any excess material that overhangs the edge of the furniture. Be careful not to cut into the furniture itself.

5. Sand and Finish

Sand the edges of the edgebanding flush with the surface of the furniture. Use a fine-grit sandpaper or sanding block to smooth out any rough edges. Wipe away any dust or debris with a clean rag or cloth.

Tips for Applying Non-Adhesive Edgebanding
Use a sharp edgebanding trimmer to ensure a clean, precise cut.
Apply the adhesive evenly to both surfaces to ensure a strong bond.
Allow the adhesive to dry for the recommended time before applying the edgebanding.
Press down firmly on the edgebanding to ensure a secure fit.
Use a sanding block or fine-grit sandpaper to smooth out any rough edges after trimming.

By following these steps, you can successfully apply non-adhesive edgebanding to furniture, creating a professional and finished look.

2024-12-17

Previous：Commercial Woodworking: How to Trim and Apply Edge Banding

Next：Will Window Frames Fall Apart if Edged with Edge Banding?