How to Remove Kitchen Cabinet Edge Banding172

Edge banding is a thin strip of material that is applied to the exposed edges of kitchen cabinet doors, drawers, and other components. It is used to protect the edges from moisture, wear, and tear. Over time, edge banding can become damaged or peeled, and it may need to be replaced. Replacing edge banding is a relatively simple task that can be completed with a few basic tools and materials.

Tools and Materials* Utility knife
* Pry bar
* Hammer
* New edge banding
* Wood glue
* Iron
* Damp cloth

Instructions1. Remove the old edge banding. Using a utility knife, carefully score the edge banding along its entire length. Be careful not to cut into the wood of the cabinet. Once the edge banding has been scored, use a pry bar to gently pry it away from the wood. If the edge banding is particularly difficult to remove, you can use a hammer to tap the pry bar gently.
2. Clean the edges of the cabinet. Once the old edge banding has been removed, clean the edges of the cabinet with a damp cloth to remove any dirt or debris.
3. Apply wood glue to the edges of the cabinet. Apply a thin layer of wood glue to the edges of the cabinet where the new edge banding will be applied.
4. Apply the new edge banding. Press the new edge banding into place on the edge of the cabinet. Use a hammer to tap the edge banding into place, making sure that it is flush with the surface of the cabinet.
5. Iron the edge banding. Use an iron to heat the edge banding and activate the wood glue. Hold the iron over the edge banding for a few seconds, and then move it down the length of the cabinet. Be careful not to overheat the edge banding, as this can cause it to bubble or melt.
6. Wipe away any excess wood glue. Once the edge banding has been ironed into place, wipe away any excess wood glue with a damp cloth.
7. Allow the wood glue to dry. Allow the wood glue to dry for at least 24 hours before using the cabinet.

Tips* If the edge banding is particularly thick, you may need to use a router to create a rabbet joint before applying the new edge banding.
* If the edge banding is curved, you can use a heat gun to soften it before bending it into place.
* If you are not comfortable replacing edge banding yourself, you can hire a professional to do it for you.

2024-12-29

Previous：How to Straighten Edge Banding

Next：How to Select the Right Model of Edge Banding?