How to Edge Band with Wood Moulding315

Edge banding is a process of covering the exposed edges of plywood, MDF, or other wood panels with a thin strip of material, such as wood or plastic. This not only improves the appearance of the panel, but also protects the exposed edges from moisture and damage. Wood moulding is a popular choice for edge banding, as it is relatively inexpensive, easy to work with, and available in a variety of profiles and finishes.

There are two main methods of edge banding with wood moulding: using a router, or using a hand-held edge bander. If you are using a router, you will need to purchase a dedicated edge banding bit. These bits are designed to cut a groove in the edge of the panel, which the wood moulding will then fit into. Once you have cut the groove, you can apply adhesive to the moulding and press it into place. Using a hand-held edge bander is a more portable option, but it can be more difficult to get a perfect fit. However, with a little practice, you can achieve professional-looking results.

No matter which method you choose, there are a few general steps that you should follow to edge band with wood moulding. First, you will need to prepare the panel by sanding the edges smooth. Next, you will need to apply adhesive to the edge of the panel. You can use a brush or a roller to apply the adhesive, but be sure to apply it evenly. Once you have applied the adhesive, you can press the wood moulding into place. Use a rubber mallet or a J-roller to press the moulding firmly into the groove. Finally, you will need to trim the excess moulding and sand the edges smooth.

Edge banding with wood moulding is a relatively simple process that can be completed in a few hours. By following these steps, you can achieve professional-looking results that will improve the appearance and durability of your wood panels.

Here are some additional tips for edge banding with wood moulding:
Use a sharp router bit. A dull bit will tear the wood and make it difficult to get a clean cut.
Apply the adhesive evenly. Too much adhesive can cause the moulding to bubble or wrinkle. Too little adhesive can cause the moulding to come loose.
Press the moulding firmly into place. Use a rubber mallet or a J-roller to press the moulding firmly into the groove. This will help to ensure a good bond.
Trim the excess moulding carefully. Use a sharp utility knife to trim the excess moulding flush with the edge of the panel.
Sand the edges smooth. Use a fine-grit sandpaper to sand the edges of the moulding smooth. This will help to remove any sharp edges and create a professional-looking finish.

2024-12-29

Previous：Edge Banding for Woodworking: How Good is Mitered Edge Banding?

Next：How to Cut Edge Banding for Perfect Right Angles