How to Edge Band with Wide Veneer332

Wide veneer edge banding is a great way to add a touch of elegance and sophistication to your furniture projects. However, it can be a bit tricky to get the hang of, especially if you're new to woodworking. In this article, we'll walk you through the steps of how to edge band with wide veneer, so you can get professional-looking results every time.

What You'll Need* Wide veneer edge banding
* Wood glue
* A hot iron
* An edge banding trimmer
* A flush trim bit

Step 1: Prepare the Edge of the SubstrateThe first step is to prepare the edge of the substrate that you'll be applying the veneer to. The edge should be clean and free of any debris. If the edge is rough, you can sand it smooth with a fine-grit sandpaper.

Step 2: Apply Wood Glue to the Edge of the SubstrateOnce the edge of the substrate is prepared, apply a thin layer of wood glue to the edge. Be sure to spread the glue evenly across the entire surface of the edge.

Step 3: Apply the Veneer to the Edge of the SubstrateNext, apply the veneer to the edge of the substrate. Start by aligning the edge of the veneer with the edge of the substrate. Then, press the veneer down onto the substrate, using a hot iron to apply pressure. Be sure to hold the iron in place for a few seconds, so that the glue has time to bond.

Step 4: Trim the Excess VeneerOnce the veneer has been applied, use an edge banding trimmer to trim the excess veneer from the top and bottom edges of the substrate. Be sure to use a sharp blade, and be careful not to cut into the substrate.

Step 5: Flush Trim the VeneerFinally, use a flush trim bit to flush trim the veneer with the surface of the substrate. This will give the veneer a clean, finished look.

Tips for Success* Use a high-quality veneer that is at least 1/16 inch thick.
* Apply a thin layer of wood glue to the edge of the substrate before applying the veneer.
* Use a hot iron to apply pressure to the veneer as it is being applied.
* Hold the iron in place for a few seconds, so that the glue has time to bond.
* Use a sharp blade when trimming the excess veneer.
* Be careful not to cut into the substrate when trimming the veneer.
* Use a flush trim bit to flush trim the veneer with the surface of the substrate.

2024-12-30

Previous：How to Use Shoe Cabinet Edging Strips Like a Pro

Next：Are Edge Bands Recyclable? A Comprehensive Guide from a Chinese Furniture Trim Factory