How to Replace Cracked Edge Banding on Chinese Furniture320

Edge banding is a thin strip of material that is applied to the exposed edges of furniture panels to protect them from damage and to improve the overall appearance of the piece. Over time, edge banding can become cracked or damaged, which can detract from the appearance of the furniture and make it more susceptible to further damage. Fortunately, replacing cracked edge banding is a relatively simple process that can be done at home with a few basic tools and materials.

Materials you will need:
New edge banding material
Iron or heat gun
Edge banding trimmer
Sandpaper
Tack cloth

Instructions:
Remove the old edge banding. Using a sharp utility knife, score the old edge banding along the length of the panel. Be careful not to cut into the panel itself. Once you have scored the edge banding, you should be able to peel it off by hand.
Clean the surface of the panel. Use a tack cloth to remove any dust or debris from the surface of the panel. This will help to ensure that the new edge banding will adhere properly.
Apply the new edge banding. Cut the new edge banding to the length of the panel. Apply a thin layer of wood glue to the back of the edge banding, and then press it into place on the panel. Use a heat gun or iron to melt the glue and bond the edge banding to the panel. Be sure to apply even pressure along the entire length of the edge banding.
Trim the excess edge banding. Once the edge banding has cooled, use an edge banding trimmer to trim off any excess material. Be careful not to trim too much, as this could damage the edge banding.
Sand the edge banding. Use a fine-grit sandpaper to sand the edge banding until it is smooth and flush with the surface of the panel.

Here are some additional tips for replacing cracked edge banding:
* If the panel is particularly thick, you may need to use a router to create a rabbet for the edge banding. This will help to ensure that the edge banding is secure and will not come loose over time.
* If you are replacing edge banding on a curved panel, you will need to use a heat gun to bend the edge banding to the shape of the panel. Be careful not to overheat the edge banding, as this could cause it to bubble or blister.
* Once you have replaced the edge banding, you should apply a clear finish to protect it from damage. This could be a varnish, lacquer, or polyurethane.
Replacing cracked edge banding is a relatively simple process that can be done at home with a few basic tools and materials. By following these steps, you can restore the appearance of your furniture and protect it from further damage.

2025-01-07

Previous：How to Apply Adhesive to Furniture Edging Strips

Next：How to Produce Edge Banding from an Edge Banding Machine