How to Bend Edge Banding66

Edge banding is a thin strip of material applied to the exposed edges of wood panels, providing a finished look and protecting the wood from damage. Edge banding can be made from a variety of materials such as wood, PVC, veneer, and acrylic, and comes in a wide range of colors and finishes.

Bending edge banding into curves is a common technique used to create curved furniture or cabinetry. While it can be a challenging task, it is possible to achieve professional-looking results with the right tools and techniques.

Tools and Materials* Edge banding
* Heat gun or hair dryer
* Bending iron or press
* Clamps
* Snips or scissors
* Measuring tape

Instructions1. Prepare the edge banding: Measure the length of the curve and cut the edge banding to size. If using a heat gun, hold it about 2 inches from the edge banding and move it back and forth until the material becomes pliable. If using a hair dryer, set it to the highest heat setting and hold it closer to the edge banding.
2. Bend the edge banding: Once the edge banding is pliable, use the bending iron or press to gently bend it into the desired curve. Make sure to apply even pressure along the length of the edge banding. You may need to reheat the edge banding several times to achieve a smooth curve.
3. Clamp the edge banding: Once the edge banding is bent, clamp it to the workpiece using clamps. Make sure the edge banding is aligned flush with the edge of the workpiece and that there are no gaps between the two.
4. Trim the edge banding: Once the glue has dried, use snips or scissors to trim any excess edge banding. Make sure to cut the edge banding flush with the edge of the workpiece.
5. Sand the edge banding: Sand the edge banding lightly to remove any sharp edges or imperfections.

Tips* Use a sharp blade to cut the edge banding to ensure a clean cut.
* Be careful not to overheat the edge banding, as this can cause it to scorch or melt.
* If the edge banding is too thick or stiff to bend easily, you can try soaking it in warm water for a few minutes to soften it.
* If you don't have a bending iron or press, you can use a piece of scrap wood to create a makeshift bending jig. Simply clamp the edge banding to the scrap wood and bend it around the edge of the jig.
With a little practice, you can master the art of bending edge banding and create beautiful curved furniture and cabinetry.

2025-01-09

Previous：Does Edge Banding Require Holes?

Next：Is Edge Banding Charged Separately?