How to Apply Veneer Edge Banding to Plywood127

Veneer edge banding is a thin strip of wood veneer that is applied to the edges of plywood to create a seamless and finished look. It is a popular choice for furniture makers and woodworkers because it is relatively easy to apply and can be used to create a variety of different looks. In this guide, we will show you how to apply veneer edge banding to plywood.

Materials you will need:
Veneer edge banding
Plywood
Contact cement
Edge banding trimmer
Sandpaper
Tack cloth

Instructions:
Prepare the plywood. Start by sanding the edges of the plywood to remove any splinters or rough spots. Then, wipe the edges down with a tack cloth to remove any dust or debris.
Apply the contact cement. Apply a thin, even coat of contact cement to the edges of the plywood and the back of the veneer edge banding. Allow the contact cement to dry for 5-10 minutes, or until it becomes tacky.
Apply the veneer edge banding. Align the veneer edge banding with the edge of the plywood and press it into place. Use a roller or a wood block to apply pressure and ensure that the veneer edge banding is securely adhered to the plywood.
Trim the excess veneer edge banding. Once the veneer edge banding is applied, use an edge banding trimmer to trim off the excess. Be careful not to trim too much, as this can damage the veneer edge banding.
Sand the edges. Sand the edges of the veneer edge banding to smooth them out and remove any sharp edges. Use a fine-grit sandpaper and sand in the direction of the grain.

Tips:
Use a sharp edge banding trimmer for best results.
If you are applying veneer edge banding to a curved surface, you can use a heat gun to soften the veneer and make it more pliable.
Be sure to allow the contact cement to dry completely before applying the veneer edge banding.
If you are applying veneer edge banding to a large piece of plywood, you may need to use clamps to hold the veneer edge banding in place while the contact cement dries.

Conclusion:Applying veneer edge banding to plywood is a relatively easy process that can be used to create a variety of different looks. By following the steps in this guide, you can achieve professional-looking results.

2025-01-10

Previous：Are All Edge Bands Adhesive?

Next：How to Choose the Right Edge Banding for the Summer