How to Remove Double Sided Edge Banding111

Double sided edge banding, also known as pre-glued edge banding, is a convenient and efficient way to finish the edges of your workpieces. However, when it comes time to remove or replace the edge banding, it can be a bit tricky. Here are a few tips on how to remove double sided edge banding:

1. Heat It Up

The first step is to heat up the edge banding. This will loosen the adhesive and make it easier to remove. You can use a heat gun or a hair dryer to do this. Be careful not to overheat the edge banding, as this could damage the workpiece.

2. Pry It Loose

Once the edge banding is heated up, you can start to pry it loose. Use a thin putty knife or a razor blade to gently pry the edge banding away from the workpiece. Be careful not to damage the workpiece.

3. Use a Solvent

If the edge banding is still stuck on, you can try using a solvent to loosen the adhesive. Apply the solvent to the edge banding and let it sit for a few minutes. Then, try to pry the edge banding loose again.

4. Sand It Off

If the edge banding is still stuck on, you can sand it off. Use a fine-grit sandpaper and sand the edge banding until it is flush with the workpiece. Be careful not to sand the workpiece too much.

5. Replace the Edge Banding

Once you have removed the old edge banding, you can replace it with new edge banding. Apply a thin layer of adhesive to the edge of the workpiece and then press the new edge banding into place. Trim the excess edge banding and you're done!

Additional Tips

Here are a few additional tips for removing double sided edge banding:
Use a sharp blade to cut the edge banding. A dull blade will tear the edge banding and make it more difficult to remove.
Be careful not to overheat the edge banding. Overheating can damage the edge banding and the workpiece.
If you are using a solvent to loosen the adhesive, be sure to wear gloves and eye protection.
Sand the edge banding in the direction of the grain. This will help to prevent the edge banding from tearing.

Conclusion

Removing double sided edge banding can be a bit tricky, but it is possible with a little patience and care. By following these tips, you can remove the edge banding without damaging the workpiece.

2025-01-25

Previous：How Furniture Edging Factory Recycling Edge Banding Glue Heads

Next：Is Selling Edge Banding a Good Career?