How to Cut a 90-Degree Angle on Edge Banding44

Introduction

Edge banding is a thin strip of material that is applied to the edges of a piece of wood, plastic, or metal to cover the exposed core material and provide a finished look. It is available in a variety of materials, including wood, plastic, and metal, and can be applied using a variety of methods, including hand-held tools, table saws, and edge banding machines.

Step 1: Measure and Mark the Cut

The first step is to measure and mark the cut. Use a ruler or measuring tape to determine the length of the edge banding that you need to cut. Mark the cut on the edge banding using a pencil or marking knife.

Step 2: Align the Edge Banding

Once you have measured and marked the cut, align the edge banding on the edge of the workpiece. Make sure that the edge banding is flush with the edge of the workpiece and that the cut is aligned with the mark that you made in Step 1.

Step 3: Clamp the Edge Banding

Once the edge banding is aligned, clamp it in place. This will help to prevent the edge banding from moving while you are cutting it.

Step 4: Cut the Edge Banding

Use a sharp knife or miter saw to cut the edge banding. If you are using a knife, be careful not to cut too deeply into the workpiece. If you are using a miter saw, set the saw blade to a 90-degree angle and make sure that the edge banding is secure in the miter saw fence.

Step 5: Remove the Clamps

Once the edge banding is cut, remove the clamps. Be careful not to damage the edge banding while you are removing the clamps.

Step 6: Trim the Edge Banding

If necessary, trim the edge banding to the desired length. Use a sharp knife or miter saw to trim the edge banding. Be careful not to cut too much off the edge banding, as this could cause it to become too short to cover the edge of the workpiece.

Step 7: Apply the Edge Banding

Once the edge banding is cut and trimmed to the desired length, apply it to the edge of the workpiece. Use a wood glue to adhere the edge banding to the workpiece. Make sure that the edge banding is applied evenly and that there are no gaps between the edge banding and the workpiece.

Step 8: Trim the Excess Edge Banding

Once the edge banding has been applied, trim any excess edge banding that is hanging over the edge of the workpiece. Use a sharp knife or miter saw to trim the excess edge banding. Be careful not to cut too much off the edge banding, as this could cause it to become too short to cover the edge of the workpiece.

Step 9: Sand the Edge Banding

Once the excess edge banding has been trimmed, sand the edge banding to smooth out any rough edges. Use a fine-grit sandpaper and sand in the direction of the grain. Be careful not to sand too much off the edge banding, as this could cause it to become too thin and weak.

Step 10: Finish the Edge Banding

Once the edge banding has been sanded, you can finish it with a variety of finishes, including paint, stain, or lacquer. The finish that you choose will depend on the desired look and the type of edge banding that you are using.

2025-01-27

Previous：White Edge Banding: Does It Fade?

Next：How to Install Edge Banding for a Flawless Look