How to Bend Edge Banding: A Step-by-Step Guide150

As a leading manufacturer of edge banding in China, we are often asked how to bend edge banding. Edge banding is a thin strip of material that is applied to the edges of plywood, MDF, or other substrates to create a finished look. It is available in a variety of materials, including PVC, ABS, and melamine, and can be either pre-glued or non-glued.

Bending edge banding can be a tricky process, but with the right tools and techniques, it can be done easily. Here are step-by-step instructions on how to bend edge banding:

Materials You'll Need* Edge banding
* Heat gun or hair dryer
* Soft cloth or rag
* Bending iron or curved surface

Instructions1. Prepare the edge banding. If you are using pre-glued edge banding, cut it to the desired length and remove the backing paper. If you are using non-glued edge banding, apply a thin layer of wood glue to the back of the banding.
2. Heat the edge banding. Use a heat gun or hair dryer to heat the edge banding until it becomes pliable. Be careful not to overheat the banding, as this can cause it to melt or bubble.
3. Bend the edge banding. Use a bending iron or curved surface to bend the edge banding to the desired shape. Be sure to apply even pressure to the banding to prevent it from tearing or cracking.
4. Cool the edge banding. Once the edge banding has been bent to the desired shape, allow it to cool completely. This will help the banding to set in place.
5. Trim the excess edge banding. Use a sharp utility knife to trim any excess edge banding that is overhanging the edge of the substrate.

Tips* Use a heat gun or hair dryer with a low setting to avoid overheating the edge banding.
* Be careful not to apply too much pressure when bending the edge banding, as this can cause it to tear or crack.
* If you are bending a large piece of edge banding, it may be helpful to use a helper to assist you.
* If you are having difficulty bending the edge banding, you can try using a bending iron or curved surface to help you.

ConclusionBending edge banding is a relatively easy process that can be done with the right tools and techniques. By following the steps outlined in this guide, you can achieve professional-looking results every time.

2025-01-29

Previous：Are Furniture Edge Bands Toxic?

Next：Which Type of Edge Banding is Best for Edge Banding Machines?