How to Replace Furniture Edging Strips143

IntroductionFurniture edging strips are an essential part of any piece of furniture, as they protect the edges of the furniture from damage and wear. Over time, however, these strips can become damaged or worn out and need to be replaced. Replacing furniture edging strips is a relatively simple task that can be completed in a few steps.

Materials You Will Need- New furniture edging strips
- Measuring tape
- Utility knife
- Contact cement
- Rag
- Sandpaper
- Tack cloth

Instructions1. Measure the length of the edge that needs to be replaced.
2. Cut a new edging strip to the desired length.
3. Apply a thin layer of contact cement to the back of the new edging strip.
4. Apply a thin layer of contact cement to the edge of the furniture.
5. Align the new edging strip with the edge of the furniture and press it into place.
6. Use a rag to smooth out the new edging strip and remove any excess contact cement.
7. Sand the edges of the new edging strip to smooth them out.
8. Wipe the surface of the new edging strip with a tack cloth to remove any dust or debris.

Tips- When choosing a new edging strip, be sure to select one that is the same thickness as the old edging strip.
- If the old edging strip is damaged, you may need to remove it with a utility knife before installing the new edging strip.
- Be sure to apply the contact cement evenly to both the new edging strip and the edge of the furniture.
- Allow the contact cement to dry for a few minutes before pressing the new edging strip into place.
- Use a light touch when sanding the edges of the new edging strip to avoid damaging the strip.

ConclusionReplacing furniture edging strips is a simple task that can be completed in a few steps. By following the instructions above, you can easily replace the edging strips on your furniture and keep it looking its best.

2025-02-12

Previous：How to Roll Edge Banding into a Coil

Next：How to Repair Edge Banding Chips in Furniture Manufacturing