How to Fix Detached Veneer Edge Banding203

Veneer edge banding is a thin strip of wood or plastic that is applied to the edges of plywood or other wood products to create a finished look. It is typically glued in place, but over time, the glue can fail, causing the edge banding to detach. If this happens, there are a few things you can do to fix it.

1. Check the glue. The first step is to check the glue that was used to apply the edge banding. If the glue is still intact, you may be able to simply reactivate it by applying heat. You can do this with a heat gun or a hair dryer. Once the glue is reactivated, press the edge banding back into place and hold it there for a few minutes until the glue has cooled and set.

2. Apply new glue. If the old glue is not intact, you will need to apply new glue. You can use any type of wood glue, but a polyurethane glue is a good choice because it is strong and durable. Apply the glue evenly to the edge of the plywood and the back of the edge banding. Then, press the edge banding back into place and hold it there for a few minutes until the glue has set.

3. Use a clamp. If the edge banding is not staying in place, you can use a clamp to hold it while the glue dries. Place the clamp over the edge banding and tighten it until the edge banding is firmly in place. Leave the clamp in place for at least 24 hours to allow the glue to dry completely.

4. Sand the edge banding. Once the glue has dried, you can sand the edge banding to smooth it out and make it flush with the surface of the plywood. Use a fine-grit sandpaper and sand with the grain of the wood. Be careful not to sand too much, or you will remove the edge banding.

5. Finish the edge banding. Once the edge banding is sanded, you can finish it with a clear finish, such as polyurethane or lacquer. This will help to protect the edge banding from damage and make it look its best.

Here are some additional tips for fixing detached veneer edge banding:
If the edge banding is badly damaged, you may need to replace it. You can purchase new edge banding at most hardware stores.
If you are having trouble getting the edge banding to stay in place, you can try using a tack hammer to drive small nails through the edge banding and into the plywood.
If you are working with a large piece of furniture, you may need to ask for help from a friend or family member to hold the edge banding in place while you apply the glue.

2025-02-12

Previous：How to Handle Defective Edge Banding and Tips for Prevention

Next：How to Edge Curve Wood Boards with Edging Strips