How to Cut 90-Degree Edge Banding299

Edge banding is a thin strip of material that is applied to the edges of plywood, MDF, or other wood panels to give them a finished look. It can be made from a variety of materials, including wood, plastic, and metal. Edge banding is available in a variety of widths and thicknesses, and can be cut to any length.

Tools You Will Need* Edge banding cutter
* Miter saw
* Measuring tape
* Pencil
* Safety glasses

Step-by-Step Instructions

1. Measure and mark the length of edge banding you need.

2. Cut the edge banding to length using a miter saw.

3. Apply a thin layer of adhesive to the back of the edge banding.

4. Position the edge banding on the edge of the wood panel, and press it into place.

5. Use an edge banding cutter to trim the excess edge banding from the top and bottom of the wood panel.

6. Sand the edge banding flush with the surface of the wood panel.

Tips* Use a sharp edge banding cutter to get a clean, precise cut.
* If you are using a hand-held edge banding cutter, be sure to wear safety glasses.
* Practice on a scrap piece of wood before you start cutting the edge banding on your project.

Troubleshooting* If the edge banding is not adhering properly, you may need to apply more adhesive.
* If the edge banding is bubbling, you may need to use a heat gun to activate the adhesive.
* If the edge banding is peeling, you may need to sand it down and reapply it.

2025-02-14

Previous：Is Edge Banding Complicated to Manufacture?

Next：How to Rapidly Rotate Your Edgebanding Inventory