How to Replace a Glue Roller on a Chinese Furniture Edging Banding Machine236

Furniture edging banding machines are essential tools for any woodworking shop. They create a clean, professional-looking finish on the edges of plywood, particle board, and other materials. One of the most important components of an edging banding machine is the glue roller. The glue roller applies a thin layer of glue to the edge of the banding material before it is pressed onto the workpiece. If the glue roller is not working properly, it can cause the banding material to peel off or come loose.

Replacing a glue roller on a Chinese furniture edging banding machine is a relatively simple process. Here are the steps you need to follow:

1. Disconnect the banding machine from the power supply.

This is a very important safety precaution. You don't want the machine to start up while you're working on it.

2. Remove the glue tank from the machine.

The glue tank is located at the front of the machine. It is held in place by two or three screws. Once you have removed the screws, you can lift the glue tank out of the machine.

3. Remove the old glue roller from the glue tank.

The glue roller is held in place by a washer and a nut. Use a wrench to loosen the nut and remove the washer. You can then pull the glue roller out of the glue tank.

4. Clean the glue tank and the glue roller.

Use a damp cloth to clean the glue tank and the glue roller. This will remove any old glue or debris.

5. Insert the new glue roller into the glue tank.

Make sure that the glue roller is inserted correctly. The shaft of the glue roller should fit into the bearing in the bottom of the glue tank.

6. Replace the washer and the nut.

Use a wrench to tighten the nut. Make sure that the nut is tight enough to hold the glue roller in place, but not so tight that it damages the roller.

7. Reinstall the glue tank in the machine.

Place the glue tank back into the machine and secure it with the screws.

8. Reconnect the banding machine to the power supply.

Now you're ready to start using the banding machine again. Make sure to test the new glue roller before you start using it on any of your projects.

Here are some additional tips for replacing a glue roller on a Chinese furniture edging banding machine:
Use the correct size glue roller for your machine. The glue roller should be the same diameter as the glue tank.
Make sure that the glue roller is properly seated in the glue tank. If the glue roller is not seated properly, it can cause the glue to leak out of the tank.
Clean the glue tank and the glue roller regularly. This will help to prevent the glue from building up and clogging the system.
If you are having problems with your glue roller, consult your machine's manual or contact the manufacturer.

2025-02-17

Previous：What is Panel Edgebanding and Why You Need It

Next：How to Hide Edge Banding on Cabinet Doors