How to Remove Hot Melt Glue from Edge Banding88

As a leading manufacturer of edge banding in China, we often receive inquiries about the best way to remove hot melt glue from edge banding. Hot melt glue is a strong adhesive that is used to bond edge banding to the substrate. It is important to remove any excess glue that may have squeezed out during the application process to ensure a clean and professional-looking finish.

There are several different ways to remove hot melt glue from edge banding. The most common method is to use a heat gun or hair dryer to soften the glue and then scrape it off with a putty knife or razor blade. Another method is to use a chemical solvent, such as acetone or denatured alcohol, to dissolve the glue. However, it is important to test the solvent on a small area first to make sure that it does not damage the edge banding.

If the hot melt glue has hardened, it may be more difficult to remove. In this case, you can try using a combination of heat and solvent. First, use a heat gun or hair dryer to soften the glue. Then, apply a solvent to the glue and let it sit for a few minutes. The solvent will help to break down the glue, making it easier to scrape off.

Once you have removed the hot melt glue from the edge banding, you can clean the surface with a damp cloth. Be sure to dry the surface thoroughly before applying any new adhesive.

Here are some additional tips for removing hot melt glue from edge banding:
Always test the solvent on a small area first to make sure that it does not damage the edge banding.
Be careful not to use too much heat when removing the glue, as this can damage the edge banding.
If the glue is still not coming off, you can try using a stronger solvent, such as acetone or denatured alcohol.
Be sure to clean the surface with a damp cloth after removing the glue.

2024-10-06

Previous：How Much Does an Edge Banding Extruder Cost in Anhui, China?

Next：How to Create a Professional-Looking Wardrobe Door Edgebanding