How to Edge Band a 90 Degree Angle Strip18

When it comes to edge banding, one of the most common challenges is how to handle 90-degree angles. These angles can be tricky to get right, but with the right technique, you can achieve a professional-looking finish.

Materials:* Edge banding material
* Hot melt adhesive
* Edge banding trimmer
* Sandpaper
* Iron
* Damp cloth

Instructions:1.

Prepare the edge banding material

Cut the edge banding material to the desired length. Make sure that the material is slightly longer than the edge of the workpiece.
2.

Apply hot melt adhesive

Apply a thin layer of hot melt adhesive to the edge of the workpiece. Be sure to apply the adhesive evenly.
3.

Position the edge banding material

Align the edge banding material with the edge of the workpiece. Press the material down firmly to ensure that it adheres to the adhesive.
4.

Trim the excess edge banding material

Use an edge banding trimmer to trim the excess material from the top and bottom of the workpiece. This will give the edge banding a clean and finished look.
5.

Sand the edge banding material

Sand the edge banding material to smooth any rough edges. This will also help to create a seamless transition between the edge banding and the workpiece.
6.

Iron the edge banding material

Use an iron to heat the edge banding material. This will help to activate the hot melt adhesive and create a stronger bond between the material and the workpiece.
7.

Wipe down the edge banding material

Wipe down the edge banding material with a damp cloth to remove any excess adhesive or debris.
8.

Enjoy your finished project!

You have now successfully edge banded a 90-degree angle strip. With a little practice, you can achieve professional-looking results every time.

Tips:* Use a sharp edge banding trimmer for clean, precise cuts.
* If you are working with a thin edge banding material, you may need to apply two layers of adhesive.
* Be careful not to overheat the edge banding material with the iron. This can cause the material to bubble or discolor.
* If you are working with a large workpiece, it may be helpful to use a helper to hold the material in place while you are applying the edge banding.
* With a little practice, you can master the art of edge banding and create beautiful, finished pieces.

2024-10-08

---

Previous：How to Edge Band Curved Surfaces

Next：How Edge Banding Tape Revolutionizes Furniture Manufacturing