How to Edge Band Inside Corners372

Edge banding is a common technique used in woodworking to cover the exposed edges of plywood, particleboard, or MDF. It provides a clean, finished look and protects the edges from moisture and wear. When it comes to edge banding inside corners, there are specific steps and techniques to ensure a precise and professional finish.

Here's a comprehensive guide on how to edge band inside corners:

1. Preparing the Surface

Before applying the edge banding, it's essential to prepare the surface by cleaning it thoroughly. Remove any dust, dirt, or debris that may interfere with the adhesive bond. Lightly sand the edges if necessary to create a smooth surface for the edge banding to adhere to.

2. Choosing the Right Edge Banding

The type of edge banding you choose will depend on the material you're working with and the desired finish. For inside corners, it's recommended to use flexible edge banding that can easily conform to the shape of the corner.

3. Applying Adhesive

Use a thin, even layer of contact cement or hot melt adhesive to the back of the edge banding and the corresponding edge of the workpiece. Allow the adhesive to dry to the touch, following the manufacturer's instructions.

4. Positioning the Edge Banding

Carefully align the edge banding with the edge of the workpiece and press it into place. Use a roller or burnishing tool to apply firm pressure and ensure proper adhesion. Start applying from the center of the workpiece outward to avoid air bubbles.

5. Cutting the Corner

To achieve a clean and precise fit in the inside corner, it's necessary to cut the edge banding at a 45-degree angle on both ends. Use a sharp utility knife or a miter saw to make accurate cuts.

6. Joining the Ends

Apply a small amount of adhesive to the mitered edges and press them together. Use painter's tape or clamps to hold the joint in place while the adhesive dries. Sand the joint lightly to smooth out any imperfections.

7. Finishing Touches

Once the edge banding is securely in place, trim any excess material that may be hanging over the edges. Sand the entire surface of the edge banding to blend it seamlessly with the workpiece. Apply a clear finish, such as polyurethane or lacquer, to protect the edge banding from wear and moisture.

Additional Tips:* Use a sharp blade to ensure clean cuts.
* Make sure the surface is completely dry before applying the edge banding.
* Allow ample time for the adhesive to dry before handling the workpiece.
* If possible, use a vacuum cleaner to remove sawdust or debris that may affect the adhesion of the edge banding.
* Practice on a scrap piece of material before attempting to edge band the actual workpiece.

2024-10-23

Previous：How to Re-Edge Laminate with Edge Banding

Next：How to Apply Shoe Cabinet Edging Trim