How to Glue Edge Banding394

Edge banding is a thin strip of material that is applied to the edges of furniture, cabinetry, and other wood products. It can be used to cover up the raw edge of the wood, or to create a decorative finish. Edge banding can be made from a variety of materials, including wood, plastic, and metal.
To apply edge banding, you will need the following materials:
* Edge banding
* Wood glue
* A brush or roller
* A heat gun
* A J-roller or hand roller
* A sharp knife
* A sanding block

How to Glue Edge Banding1. Prepare the edge banding. If the edge banding is not pre-glued, you will need to apply a thin coat of wood glue to the back of the banding. Use a brush or roller to apply the glue evenly.
2. Apply the edge banding to the edge of the wood. Align the edge banding with the edge of the wood and press it into place. Use a J-roller or hand roller to apply pressure to the banding and ensure that it is firmly attached.
3. Heat the edge banding. Use a heat gun to heat the edge banding until it becomes pliable. This will help the glue to bond more effectively.
4. Trim the edge banding. Once the edge banding has cooled, use a sharp knife to trim off any excess material.
5. Sand the edge banding. Use a sanding block to sand the edge banding flush with the surface of the wood.

Tips for Gluing Edge Banding* Use a good quality wood glue. A strong bond will help to prevent the edge banding from peeling off.
* Apply the glue evenly to the back of the edge banding. This will help to ensure that the banding adheres evenly to the wood.
* Use a J-roller or hand roller to apply pressure to the edge banding. This will help to ensure that the banding is firmly attached to the wood.
* Heat the edge banding until it becomes pliable. This will help the glue to bond more effectively.
* Trim the edge banding carefully. Any excess material can create a rough edge.
* Sand the edge banding flush with the surface of the wood. This will help to create a smooth, finished appearance.

Troubleshooting* If the edge banding is not adhering to the wood, you may need to apply more glue. Be sure to apply the glue evenly to the back of the banding.
* If the edge banding is peeling off, you may need to heat it up again. Use a heat gun to heat the banding until it becomes pliable. Then, press it back into place.
* If the edge banding is bubbling, you may need to use a J-roller or hand roller to apply more pressure. Be sure to roll the banding in both directions to ensure that it is firmly attached.
* If the edge banding is not flush with the surface of the wood, you may need to sand it down. Use a sanding block to sand the banding until it is level with the wood.

2024-11-01

---

Previous：How to Cut Edge Banding

Next：How Edge Banders Shred Edge Banding Strips