How to Bend Edge Banding on Right-Angled Corners16

Introduction

Edge banding is a thin strip of material that is applied to the exposed edges of plywood, particleboard, or MDF to create a finished look. It can be made from a variety of materials, including wood, plastic, and metal. Edge banding is typically applied using a hot melt adhesive, which is activated by heat. Once the adhesive has melted, the edge banding is pressed into place and allowed to cool. This creates a strong bond between the edge banding and the substrate.

When applying edge banding to a right-angled corner, it is important to use a technique that will create a clean and professional-looking finish. The following steps will help you to bend edge banding on right-angled corners like a pro:

Materials
Edge banding
Hot melt adhesive
Edge bander
Corner clamp
Heat gun
Trimming tool

Step 1: Cut the Edge Banding

The first step is to cut the edge banding to the desired length. Make sure to cut the edge banding slightly longer than the length of the edge that you will be covering. This will give you some extra material to work with when you are bending the edge banding around the corner.

Step 2: Apply the Hot Melt Adhesive

Once the edge banding has been cut to the desired length, apply the hot melt adhesive to the back of the edge banding. Use a thin, even coat of adhesive, and make sure to cover the entire surface of the edge banding. The hot melt adhesive will help to keep the edge banding in place and prevent it from peeling off.

Step 3: Apply the Edge Banding

Once the hot melt adhesive has been applied, press the edge banding into place on the edge of the substrate. Use a corner clamp to hold the edge banding in place while the adhesive dries. The corner clamp will help to prevent the edge banding from shifting or moving out of place.

Step 4: Bend the Edge Banding

Once the adhesive has dried, it is time to bend the edge banding around the corner. To do this, use a heat gun to heat up the edge banding. As the edge banding heats up, it will become more pliable and easier to bend. Use your fingers to gently bend the edge banding around the corner. Be careful not to bend the edge banding too far, as this could cause it to crack or break.

Step 5: Trim the Edge Banding

Once the edge banding has been bent around the corner, use a trimming tool to trim off any excess material. Use a sharp blade to make clean, straight cuts. Be careful not to cut into the substrate.

Step 6: Finish the Edge Banding

Once the edge banding has been trimmed, you can finish it by applying a clear coat of finish. This will help to protect the edge banding and give it a professional-looking finish. You can also use a sanding block to smooth out any rough edges.

Conclusion

By following these steps, you can bend edge banding on right-angled corners like a pro. With a little practice, you will be able to create clean and professional-looking finishes that will enhance the appearance of your furniture and other woodworking projects.

2025-01-14

Previous：How to Cut Aluminum Trim for Baseboards

Next：How to Install Baseboard Molding for Cabinets