How to Apply Edge Banding to Plywood157

Edge banding is a thin strip of material that is applied to the edges of plywood to give it a finished look. It can be made from a variety of materials, including wood, plastic, and metal. Edge banding is available in a variety of colors and finishes, so you can choose the one that best matches your décor.

Applying edge banding is a relatively simple process, but it does require some precision. If you are not careful, you can end up with uneven or misaligned edge banding. To avoid this, it is important to follow the steps carefully.

Materials You Will Need
Edge banding
Iron
Edge banding trimmer
Sandpaper

Instructions

1. Cut the edge banding to the desired length. The edge banding should be slightly longer than the edge of the plywood.

2. Apply a thin layer of glue to the edge of the plywood. Use a brush or a roller to apply the glue evenly.

3. Place the edge banding on the edge of the plywood. Align the edge banding carefully so that it is flush with the edge of the plywood.

4. Use an iron to heat the edge banding. The heat will activate the glue and bond the edge banding to the plywood.

5. Use an edge banding trimmer to trim off any excess edge banding. The edge banding trimmer will give you a clean, finished edge.

6. Sand the edge of the plywood to smooth any rough edges.

Tips
Use a sharp knife to cut the edge banding. A dull knife will tear the edge banding.
Apply a thin layer of glue to the edge banding. Too much glue will make the edge banding difficult to work with.
Align the edge banding carefully before you apply the iron. Once the edge banding is heated, it will be difficult to move.
Use an edge banding trimmer to trim off any excess edge banding. The edge banding trimmer will give you a clean, finished edge.
Sand the edge of the plywood to smooth any rough edges.

2025-01-16

Previous：How to Remove Baseboard Moldings

Next：How to Install Picture Frame Molding