How to Cut Round Holes in Edge Banding201

Edge banding is a thin strip of material that is applied to the exposed edges of plywood, particleboard, or MDF to give it a finished look. Edge banding can be made from a variety of materials, including wood, plastic, and metal. One common type of edge banding is round hole edge banding, which has a series of evenly spaced round holes along its length.

Round hole edge banding is often used in applications where it is necessary to insert screws or nails through the edge banding into the substrate. The round holes allow the screws or nails to pass through the edge banding without damaging it. Round hole edge banding is also sometimes used for decorative purposes.

There are a few different ways to cut round holes in edge banding. One way is to use a drill press. To do this, first mark the locations of the holes on the edge banding. Then, use a drill bit that is slightly smaller than the desired diameter of the holes. Drill the holes all the way through the edge banding.

Another way to cut round holes in edge banding is to use a hole saw. To do this, first mark the locations of the holes on the edge banding. Then, use a hole saw that is the same diameter as the desired diameter of the holes. Cut the holes all the way through the edge banding.

If you do not have a drill press or a hole saw, you can also cut round holes in edge banding by hand. To do this, first mark the locations of the holes on the edge banding. Then, use a sharp knife or a hole punch to cut the holes. Be careful not to cut too deeply into the edge banding.

Once you have cut the round holes in the edge banding, you can apply it to the substrate using a variety of methods. One common method is to use wood glue. To do this, apply a thin layer of wood glue to the back of the edge banding and press it into place on the substrate. Another method is to use a brad nailer. To do this, use a brad nailer to drive brads through the edge banding into the substrate.

Round hole edge banding is a versatile material that can be used in a variety of applications. By following the steps outlined above, you can easily cut round holes in edge banding.

Additional Tips* When cutting round holes in edge banding, it is important to use a sharp cutting tool. A dull cutting tool will tear the edge banding and make it difficult to get a clean cut.
* It is also important to be careful not to cut too deeply into the edge banding. Cutting too deeply into the edge banding can weaken it and make it more likely to break.
* If you are cutting round holes in edge banding by hand, be sure to use a ruler or a template to mark the locations of the holes. This will help you to ensure that the holes are evenly spaced and that they are the correct size.

2025-01-20

Previous：How to Use a Knife to Trim Veneer Edge Banding

Next：Why Do You Need to Pay for Edgebanding?